Meridian Audio DVP1500 User Manual download pdf (Page 11)

The OSD consists of four menu tabs:

Input – Picture – Display – Patterns

Input Menu

Formats

Input Select: OSD

Video-S-Video- RGB-YCrCb-DVI

Note: Note: The Pass-Thru input cannot be selected

from the OSD since an OSD is not available on that

input. Use the Input button on the remote to select it.

The DVI Input will not display an OSD unless there is

a source connected to it.

Aspect Ratio*

4:3-Letterbox-Anamorphic

Note: This selection should match the aspect ratio of

the source, not the display. The aspect ratio of the

display should be selected in the Setup menu.

Profiles-

Profile: Factory-1-2-3-4-5-6-7-8

Store: 1-2-3-4-5-6-7-8

To store a Profile (in the Input Menu):

• Press Menu button on the remote

• Make all required adjustments.

• Use the Function Up/down keys to

select Profile

• Use the Value Left/Right keys to select Profile

• Press Enter

To recall a Profile (in the Input menu):

• Press Menu button on the remote

• Use the Function Up/Down keys to

select Recall

• Use the Value Left/Right keys to

select profile 1-8

• Press Store

Note: When using a 4:3 source on a Wide Angle

screen there are black bars on the left and right of the

image. The sidebars can be changed to gray using

the Blanking Level control located in the Display

menu. If filling the entire screen is desired, select

Letterbox. The image will fill the screen but the top

and bottom 1/3 of the image will be cut off

(overscanned).

When watching 2:35 aspect ratio movies on a 16:9

(1:77) screen, it is normal to see black bars at the top

and bottom of the image.

Note: The screen shape used in the installation

must be set in the Setup Menu during installation for

proper Aspect Ratio mapping. Anamorphic Aspect

Ratio with 4:3 screens and the Wide-4:3 settings are

not available on units with scan rates 480p, 540p,

600p and Frame Doubling. See Setup section

for details.

Note: Do not leave the 4:3 image with a Wide Angle

screen on for long periods of time on a CRT

projector or plasma display. This can cause

permanent image burn-in. Image burn-in is

not covered by Faroudja’s warranty

Picture Menu

Use these commands to fine-tune the image.

OSD / OPERATING INSTRUCTIONS

INPUT PICTURE DISPLAY PATTERNS

FORMATS

INPUTS DVD

ASPECT ANAMORPHIC

PROFILE

RECALL F 1 2 3 4

STORE 1 2 3 4

Press the Function UP/Down

keys until the triangle turns

Yellow. Press the Value Left/Right

keys to cycle to the Menu tabs.

Use the Value left/Right

keys to change selection

or values.

INPUT PICTURE DISPLAY PATTERNS

FORMATS

INPUTS DVD

ASPECT ANAMORPHIC

PROFILE

RECALL F 1 2 3 4

STORE 1 2 3 4

INPUT PICTURE DISPLAY PATTERNS

BRIGHTNESS 50

CONTRAST 50

COLOR 50

TINT 50

DETAIL 4

ADVANCED COLOR SYS NORMAL

Brightness

Factory 50

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Comments to this Manuals

No comments

Meridian Audio DVP1500 User Manual Page 11

Comments to this Manuals