Meridian Audio DVP1500 User Manual download pdf (Page 9)

SETUP

SETUP MENU FUNCTIONS

Set: SCANRATE

Select the required scanrate by using the right and

left arrows. When the desired rate is displayed on the

LCD display, press the STORE key on the remote or

ENTER on the front panel. The DVP1000 will ask you

"Are you sure" and press the STORE/ENTER key

again. The scanrate is now selected.

Set: Active Output

Analog/Digital (Default)

This must be selected to determine if the Analog

(BNC) or Digital (DVI) output is used. Both outputs

cannot be used at the same time.

Set: Screen Shape

Wide Screen / 4:3 / Wide 4:3

Note: This sets the processor for the screen shape of

the display to be used. If this is not set properly, the

aspect ratio selection for the different sources

located in the user menu will be incorrect.

•Wide Screen-Choose this when the screen is

Widescreen and the projector will provide the

anamorphic vertical squeeze.

Example: A 16:9 plasma, a digital or CRT projector

set to Anamorphic using a wide angle screen or when

using a Panamorph lens, or a 1280x720 digital

projector.

•4:3– Choose this when the projector is 4:3

and the screen is 4:3

Example: using a 1024x768 digital projector on a 4:3

screen.

•Wide 4:3-Choose this when the digital

projector operates as 4:3 and the screen is

Widescreen. (Not available on units scanning

at rates below 720p)

Example: A digital projector that has a 4:3 display

chip that locks the aspect ratio when sent the native

resolution and then displayed on a wide angle screen.

Output Format (Analog)

RGB (Default) /YPrPb

Note: Selecting RGB means connecting the

processor to the display via five wire analog RGBHV.

This function is not active when DVI output is

selected. DVI is always RGBHV.

Composite Sync on H

On/Off (Default)

Note: this function is not active when YPrPb

output is selected.

Horizontal Sync Polarity

Negative (Default) / Positive

Changes sync polarity, which may be needed for

compatibility with some displays.

Vertical Sync Polarity

Negative (Default) / Positive

Changes sync polarity, which may be needed for

compatibility with some displays

Note: Each input on the DVP1500 can be activated

or deactivated to simplify operation so unused inputs

are not accessed when cycling through the inputs

with the remote control.

Set: Video Input

Enabled (Default) /Disabled